INSTALLATION IF PHONE LINE HAS A RJ31-X ALARM JACK 

STEP #1 (PHONE LINE CONNECTION TESTING) This section will allow you to test the phone line connections between the Diverter and the Phone line. (1)  Unplug the 8 pin modular cord from the RJ31-X phone jack. (2) Plug the 8 pin cord from the "TELCO LINE"  side of the DIVERTER into the RJ31X PHONE JACK. (3) Using a TOUCH TONE TELEPHONE, plug its 4 pin RJ-11 CORD into middle of the 8 pin jack  on the "ALARM LINE" side of the DIVERTER. (4) If the RJ31-X was wired correctly, you should hear a dial tone when lifting the telephone handset.  If no dial tone is present, CLICK HERE.

 

 

 

 

 

 

 

 

 

STEP #2 (ACCOUNT NUMBER DISCOVERY) This section is used to discover the alarm systems existing alarm account number in order to determine what receiver line card phone number to program into the diverter so it will not clash with any existing account number alredy being reported to that receivers line card. In may cases, the Subscriber may already know the account number or it may be written on the alarm panel.  Remember, only the last 4 digits are needed.  And if you do locate the actual account number, you may be able to skip this section and proceed directly to the next section.  However, we always recommend verifying the account number using this section. (1)  Lift The handset off hook and using the touch tone keypad, enter:  #, #,1,2,3,4.

 

 

 

 

 

 

 

 

STEP #3 (DIAL OUT NUMBER & INSTALLER CODE UPDATING) This section is used to replace the pre-programmed TEST dial out number with the receiver line ard number of your choice as well as changing the installer code from 1234 to the code of your choice. (1)  Lift The handset off hook and using the touch tone keypad, enter:  [#] [#] [1] [2] [3] [4] [#] [#] A single confirmation tone will be heard if accepted.  If not, hang-up handset and repeat step 1. (2) After tone confirmation is heard, enter [*] [#] [0] [X]-[X][X][X]-[X][X][X]-[X][X][X][X] [#][#] Where [X] is the 10 digit receiver line card number beginning with the number "1". In the event a pre-dial number such as a "8" or "9" is required, replace the '0' with the digit needed. Another single confirmation tone will be heard if accepted.  If not, hang-up handset and restart at step 1. If a 3 digit tone is hard, the entry failed, but you can repat the individual step. (3) After tone confirmation is heard, enter [*] [#] [P]-[P][P][P] [#][#] Where [P] is the 4 digit installer ID of your choice. Another single confirmation tone will be heard if accepted.  If not, hang-up handset and restart at step 1. If a 3 digit tone is hard, the entry failed, but you can repat the individual step.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  

 

 

 

 

INSTALLATION IF PHONE LINE HAS NO PHONE JACK

 

 

INSTALLATION WHEN A RJ31-X ALARM JACK IS PRESENT

INSTALLATION WHEN A RJ31-X ALARM JACK IS PRESENT

INSTALLATION WHEN A RJ31-X ALARM JACK IS PRESENT

 

 

 

 

 

 

 

 

 

 

 

allation If a RJ31-X alarm jack is present.

(1) Unplug the existing